BMW 3 Series E30

since 1983-1994 release

Repair and operation of the car



BMW E30
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmissions
+ 9. Coupling
- 10. Brake system
   10.2. Specifications
   10.3. Anti-blocking system (ABS)
   10.4. Blocks of disk brakes
   10.5. Support of a disk brake
   10.6. Brake disk
   10.7. Blocks of drum brakes
   10.8. Main cylinder of brakes
   10.9. Vacuum amplifier of brakes
   10:10. Cable(s) of the emergency brake
   10:11. Adjustment of the emergency brake
   10:12. Mechanism of the emergency brake
   10:13. Brake pedal
   10:14. Braking signal switch
   10:15. Hoses and lines of a hydraulic actuator of brakes
   10:16. Removal of air from a hydraulic actuator of brakes
+ 11. Running gear
+ 12. Body
+ 13. Electric equipment
+ 14. Useful tips


4ca876a9



10.4. Blocks of disk brakes

GENERAL INFORMATION

Prevention

Blocks of brakes have to change at the same time, both on lobbies and on back wheels.


Tilting of a support for removal of blocks of a forward brake

Sensor of wear of a block of a forward brake

For removal of the sensor beat out a pin (shooter).

Cave-in of the piston in the support cylinder


PERFORMANCE ORDER
1. Uncover (also) a tank and remove two thirds of liquid.
2. Lift a forward (back) part of the car and establish on supports.
3. Remove a forward (back) wheel. Working at a brake of one wheel, you can use a brake of another as a sample.
4. Check a condition of a brake disk. If grinding is necessary, then remove a disk.
5. Turn off bolts.
6. If it is necessary to remove a brake disk, then turn off bolts of fastening of an arm of a support. At an otvorachivaniye of a bolt of fastening of a support it is necessary to hold a support axis.
7. Remove a support, the sensor of wear of blocks and an internal block. Then install an internal block on the piston and completely drown the piston in the cylinder by means of a clamp.
8. Disconnect the socket of the sensor of wear of blocks.
9. Holding guides, turn off bolts of fastening of a support.
10. Remove an external brake shoe.
For a support of a back brake
11. Disconnect the socket.
12. Remove caps and turn off bolts.
13. Remove an antinoise spring.
14. Drown the piston by means of a clamp.
15. Remove a support and an internal block.
16. Remove an internal brake shoe.
17. Fix a support by a wire.
18. Remove an external brake shoe.

Prevention

The quantity and design of antinoise slips and some other details for different models can differ. Therefore it is recommended to remember previously an arrangement of slips and other details that at assembly not to break an order of their installation.


19. Check a condition of the sensor of wear of a block (on a forward left wheel (shooter), or on forward left and back the right). If sensors in the normal state, then install them on new blocks. At detection of damages replace sensors.
20. Installation is carried out upside-down. Tighten support bolts with the set moment.
Prevention

If necessary replace bolts.


21. Upon termination of press several times a brake pedal. The pedal has to settle down at former height and has to be rigid. Check liquid level. Be convinced of lack of leaks and check work of brakes before operation of the car.

After change of blocks avoid sharp braking throughout the first several hundred km of a run.