BMW 3 Series E30

since 1983-1994 release

Repair and operation of the car


BMW E30
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling system
+ 5. Heating and ventilation
- 6. Fuel system
   6.2. Specifications
   6.3. Check of system of injection
   6.4. Air stream measuring instrument
   6.5. Throttle branch pipe
   6.6. Fuel pressure regulator
   6.7. Nozzle of launch of the cold engine and thermotimer
   6.8. Check and replacement of nozzles
   6.9. Air proofreader of idling
   6.10. Order of a decompression of fuel system
   6.11. Check of pressure of fuel
   6.12. The fuel pump, the pump of pumping and the fuel level sensor in a tank
   6.13. Fuel pipes and union
   6.14. Fuel tank
   6.15. Air filter
   6.16. Cable of the drive of a butterfly valve
   6.17. Carburetor
+ 7. Exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
+ 11. Running gear
+ 12. Body
+ 13. Electric equipment
+ 14. Useful tips


4ca876a9



6.6. Fuel pressure regulator
GENERAL INFORMATION

Fuel pressure regulator

 The regulator is reported with a cavity of the soaking-up collector through a vacuum hose.

Bolts of fastening of the regulator of pressure of fuel (L-Jetronic system)

 1. Suppressor of pulsations

2. Fastening bolts

3. Vacuum hose

Bolts of fastening of the regulator of pressure of fuel (Motronic system)

 A. Fastening bolts

B. Return fuel pipe

C. Regulator hose

Check

PERFORMANCE ORDER
1. Execute a decompression.
2. Disconnect the battery from weight.
3. Disconnect a fuel hose from the regulator and on its place install the manometer.
4. Attach the battery, connect the pump, include ignition and check existence of dribbles of fuel.
5. Attach the vacuum pump to the place of a vacuum hose, turn on the fuel pump. Consider fuel pressure during creation of depression on the regulator and without depression. Pressure of fuel has to decrease in process of depression increase.
6. Attach a vacuum hose, start the engine and consider fuel pressure idling. Disconnect a vacuum hose, – at the same time pressure has to increase sharply.
7. If pressure low, then press the return fuel pipe. If at the same time pressure does not increase, then the fuel pump is faulty or the direct fuel pipe is littered. If pressure sharply increases, then replace pressure regulator.
8. If pressure too high, then stop the engine, disconnect and blow the return fuel pipe. If the return fuel pipe is not littered, then replace pressure regulator.
9. If change of pressure does not correspond described, then check depression on the regulator, having attached the vacuum gage to the place of a vacuum hose (the engine has to idle).
10. If depression is, then replace the regulator of pressure. Otherwise believe tightness of a hose and the union on vacuum connection.

Replacement

PERFORMANCE ORDER
1. Execute a decompression and disconnect the battery from weight.
2. Disconnect the return fuel and vacuum hoses from the regulator. Turn off bolts of fastening (arrow) and remove the regulator.
3. Installation is carried out upside-down. Replace ring laying.