BMW 3 Series E30

since 1983-1994 release

Repair and operation of the car



BMW E30
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling system
- 5. Heating and ventilation
   + 5.1.2. Fan of a heater and conditioner
   - 5.2. Air conditioning system
      5.2.2. Care of air conditioning system
      5.2.3. Compressor
      5.2.4. Condenser
      5.2.5. Moisture separator
      5.2.6. Conditioner evaporator
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
+ 11. Running gear
+ 12. Body
+ 13. Electric equipment
+ 14. Useful tips


4ca876a9 гомоцистеин норма при беременности




5.2.5. Moisture separator

GENERAL INFORMATION

Moisture separator

1. Relay of high pressure
2. Highways of the conditioner
3. Relay of low pressure
4. Socket

On a part of cars the moisture separator is mounted behind a back headlight.

Removal and installation

PERFORMANCE ORDER
1. Depressurize the conditioner and remove coolant in car service.
2. Disconnect the battery from weight.
3. Remove a windshield washer reservoir.
4. Disconnect from wire moisture separator sensors (on a part of cars there can be one sensor of pressure).
5. Unscrew screws and remove a moisture separator.
6. Installation is carried out upside-down. If the new moisture separator is established, then be guided by the instruction attached to this unit, rearrange on it pressure sensors. Replace a sealing ring. Fill system with coolant in car service.