BMW 3 Series E30

since 1983-1994 release

Repair and operation of the car



BMW E30
+ 1. Maintenance instruction
- 2. Maintenance
   2.2. The recommended lubricants and liquids
   2.3. Frequency of service
   2.4. Features of routine maintenance of the car
   2.5. General information on additional maintenance
   2.6. Check of level of liquids
   2.7. Check of a condition of tires and pressure in tires
   2.8. Replacement of oil in the engine and an oil filter
   2.9. Check and restoration of level of liquid in a wheel
   2.10. Check of level of liquid in automatic transmission
   2.11. Shift of wheels
   2.12. Check and replacement of hoses in a motor compartment
   2.13. Check, adjustment and replacement of belts of the drive of hinged units
   2.14. Check and adjustment of turns and quality of mix (SO) of idling
   2.15. Check of a state and battery charging
   2.16. Check and replacement of candles
   2.17. Check of high-voltage wires, runner and cover of the distributor
   2.18. Check of level of oil in the manual transmission
   2.19. Check of level of oil in the main transfer
   2.20. Check and adjustment of gaps in valves (except the M40 engine)
   2.21. Draft of a butterfly valve
   2.22. Replacement of the air filter
   2.23. Check of fuel system
   2.24. Check of the cooling system
   2.25. Check of the exhaust system
   2.26. Check of shock-absorbers, suspension bracket and steering
   2.27. Check of covers of half shafts
   2.28. Check of brakes
   2.29. Check of brushes of screen wipers
   2.30. Replacement of liquid in automatic transmission and the filter
   2.31. The cooling system – replacement of liquid and washing
   2.32. Replacement of the fuel filter
   2.33. Replacement of oil in the manual transmission
   2.34. Replacement of oil in a case of the main transfer
   2.35. Check of system of catching of vapors of gasoline (EVAP system)
   2.36. Installation of the light alarm system of need of servicing
   2.37. Replacement of a gear belt
+ 3. Engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
+ 11. Running gear
+ 12. Body
+ 13. Electric equipment
+ 14. Useful tips


4ca876a9



2.16. Check and replacement of candles

GENERAL INFORMATION

New candles have to correspond to engine type.

PERFORMANCE ORDER
1. Check a gap between candle electrodes by means of the round probe. The probe has to move between electrodes under small effort.
2. If necessary turn in a side electrode. It is necessary to turn in an electrode near a bend. Turn out candles on one.
3. Disconnect a wire from a candle, holding a tip and slightly turning them.
4. Clear and blow compressed air of the platform near candles and turn out candles.
5. Check the turned-out candle and estimate an engine condition.
6. Grease a carving of a new candle with structure from a holding strap on a copper basis, insert and turn by hand, then tighten with the set moment.
7. Check a condition of wires (see subsection 2.17), dress a wire on a candle, slightly rotating tips and pressuring them. Repeat the procedure for other candles.