BMW 3 Series E30

since 1983-1994 release

Repair and operation of the car

BMW E30
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmissions
- 9. Coupling
   9.2. Specifications
   9.3. Coupling check
   9.4. Main cylinder of coupling
   9.5. Coupling pedal
   9.6. The blocking coupling switch
   9.7. Working cylinder of coupling
   9.8. Removal of air from a coupling hydraulic actuator
   9.9. Coupling details
   9.10. Driveshaft
   9.11. Elastic coupling
   9.12. Average support
   9.13. Cardan hinges
   9.14. The forward aligning plug
   9.15. Driveshaft CV JOINT
   9.16. Half shafts
   9.17. CV JOINTS and covers
   9.18. Epiploons of a reducer of a back axis
   9.19. Reducer of a back axis
   9.20. Epiploon of the leading gear wheel of a reducer
+ 10. Brake system
+ 11. Running gear
+ 12. Body
+ 13. Electric equipment
+ 14. Useful tips

9.7. Working cylinder of coupling

Removal and installation

PERFORMANCE ORDER

1. Remove liquid from a coupling hydraulic actuator tank.
2. Lift a car front.
3. Disconnect a coupling hydraulic actuator hose, for this purpose it is required to shoot the cylinder with parts of cars.
	4. Turn off nuts and remove the cylinder. 1. Hydraulic actuator hose 2. Nuts 3. The union for removal of air
5. Check wear of a plastic pusher of a head and the lever of a pusher. The lever as a rule wears out only in deepening under a pusher. The increased wear on each side and on the lever out of deepening indicates heads of a pusher violation of axial provision of a pusher.
6. At detection of a leak through consolidation of a pusher replace the cylinder. When replacing consider that on models with a usual flywheel the cylinder with an internal diameter of 20,64 mm, and on models with a dual flywheel – with an internal diameter of 22,2 mm is installed.
7. Installation is carried out upside-down. Grease a pusher head with molybdenic lubricant and be convinced that the pusher came into deepening on the lever. Fill in liquid and remove air.